Pre-checks

Possibly the recommendations that you are going to read below have already been carried out before certifying that something strange was happening to the speakers of your iPhone X. However, we believe it advisable to note these previous steps to certify that all the settings are correct:

  • Turn up the volume of your iPhone to the maximum, either with the buttons or from Settings> Sounds and vibrations.
  • Make sure the mode Do not disturb is disabled.
  • Test the sound in various applications.
  • Try to make a call and check if you listen to the other person.

If you have checked this and realized that the bug is still present, you can continue reading this article to find a solution. If with these checks you have been able to solve the failure, obviously you will not need to continue reading because you already found the problem with your iPhone X.

Dirt on the speakers

No matter how neat and careful you are with your iPhone, it is possible that a small speck of dust or other debris has embedded in the speakers. In fact, it is the most normal thing in the world considering that we leave the mobile on multiple surfaces, we store it in pockets, backpacks, bags, suitcases … The fact that there is dirt inside can make the sound sound distorted and even that cover it completely.

For clean the speakers It is recommended to always use utensils that cannot damage them, as they are made of very sensitive materials. For this reason, the recommendation that Apple itself makes is to use small, lint-free swabs. or soft bristle toothbrushes.

Water and moisture damage

Water, and humidity in general, are the main enemies of electronic devices. It is true that the iPhone X has IP67 certification, which guarantees protection against water and dust, but in the end nothing is forever and despite having a good seal, in the end over time the material can wear out. and make water can enter the interior of the iPhone. In principle this could be affecting only the speakers, but it cannot be ruled out that it reaches the plate and ends up rendering the device useless.

Therefore, if your iPhone has recently gotten wet and you have even taken a bath with it in the pool or on the beach, you should take it to repair yes or yes, because at 99% it will be the cause of the speakers not working. For this, you must make an appointment in advance at an Apple Store or Authorized Technical Service. Once you take the terminal to one of them, they will carry out a diagnosis and offer you the repair estimate.

Bumps and falls

There is no doubt that phones are increasingly manufactured with more premium materials and, on paper, more resistant. But it is also undeniable that these are much more sensitive to shocks and drops than the old phones we had years ago. That is why each component that makes up the iPhone can be affected by any blow or fall.

If your iPhone X has suffered a fall or strong blow Recently, you may not have noticed an apparent glitch at first, but now it’s showing up on the speaker. This may or may not be accidental, but depending on the severity of the blow it may be more related. Therefore, you would have no choice but to go to repair.

Factory fault and free repair

On some occasions there have been cases where several batches of iPhones have been affected by a common factory defect and Apple has opened a free repair program for them. With the iPhone X and the speakers there has been nothing similar, so it is ruled out that it could be a general problem. However, it cannot be ruled out that your specific terminal may have a manufacturing defect affecting the loudspeaker.

Apple Support iPhone repair

That is why going for repair to an Apple Store or Authorized Technical Service can be key. If your iPhone X is still under warranty and it is certified that it is not damaged by blows or humidity, surely they will access repair it free of charge.

Could the software be the problem?

Despite the fact that a problem appears in such a way that it appears hardware, as is the case with your iPhone X and its speakers, the truth is that it can sometimes derive from a software failure. It is not the most common, but perhaps a bug in the operating system could be the culprit that you have these problems, especially if they are intermittent failures and do not occur continuously. The first option we find is that of update software, for which you must go to Settings> General> Software update and check if there is a newer iOS version available and, in that case, download and install it.

It may also be that the iOS bug is manifested because of some type of internal file that is causing problems. This is not common either, but sometimes it can occur when backups are installed on an iPhone after having been previously installed on other computers. In fact, it is recommended that clean installations be carried out from time to time to avoid this type of problem. For this you should restore iOS and configure the device as new iPhone.

Leave a comment

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.