High-flux extreme-ultraviolet light at 13.5 nanometres has been generated from a green-wavelength driver for the first time, reaching power levels relevant for semiconductor lithography, researchers reported in Nature on May 22.
The team, led by Thomas Gaumnitz at the Max Born Institute for Nonlinear Optics and Short Pulse Spectroscopy in Berlin, produced 2.7 microwatts of 37th-harmonic radiation within the 2 per cent bandwidth required for extreme-ultraviolet lithography. That output exceeds previous high-harmonic results at that wavelength by more than an order of magnitude, the paper said.
“It was not obvious that we could reach the lithography window with a 516-nanometre driver,” Gaumnitz said in an interview. “The phase-matching pressure scales with wavelength, so shorter drivers usually mean lower density and lower flux. But the plasma-core guiding we observe stabilizes the intensity exactly where we need it.”
Most high-harmonic sources for 13.5-nanometre light use infrared drivers around 800 nanometres or longer. The Berlin group instead started with a ytterbium-based laser emitting at 1,030 nanometres, frequency-doubled it to 516 nanometres — green light — and compressed the pulses to below 20 femtoseconds after spectral broadening in a helium-filled multipass cell.
Focusing those pulses into a helium gas jet created a plasma channel that defocused the beam just enough to clamp the on-axis intensity at roughly 0.9 petawatts per square centimetre, near the barrier-suppression intensity of helium. Simulations confirmed that this self-regulated “plasma-core guiding” extends over approximately two absorption lengths, allowing the harmonic field to build up coherently rather than being re-absorbed.
Blueshift locks harmonic into lithography band
Conventional high-harmonic generation with a 516-nanometre driver would place the 37th harmonic at 88.9 electronvolts, outside the 91.8-eV (13.5-nanometre) lithography window. The experiment, however, measured a pronounced blueshift of the driving spectrum during the initial plasma formation. That shift is multiplied by the harmonic order, pushing the 37th harmonic into the required band.
The simulated spectra reproduce both the shifted position and the measured pressure dependence of the harmonic yield, the paper said. At the experimental input energy, the conversion efficiency from driver to HH37 reaches 10⁻⁶, while the lower-order HH33 hits 7.3 microwatts across its full linewidth.
Phase matching in the stabilized regime
Analysis of the local coherence length shows that phase matching is achieved in the central, stabilized section of the plasma channel. There, the dipole emission becomes nearly stationary and overlaps with a region of long coherence length created by the balanced neutral and plasma dispersion. The harmonic flux grows monotonically through this region, indicating operation close to the absorption limit.
Toward the end of the gas jet, the falling gas density reduces the coherence length even though the driving intensity remains clamped, the simulations show. The temporal profile of the spectrally filtered HH37 emission peaks near the maximum of the reshaped driver envelope, at an ionization fraction of about 1.2 per cent — matching the critical ionization fraction predicted by standard strong-field phase-matching theory.
Why the green driver matters for scaling
Shorter driving wavelengths reduce the single-atom dipole phase and lower the critical ionization fraction for phase matching, both of which favor higher conversion efficiency. The Berlin results demonstrate that plasma-core guiding naturally establishes the required ionization conditions at higher regulated intensities than longer-wavelength drivers can sustain.
“Because the stabilized intensity is set by the gas species, not the laser parameters, we get a robust operating point,” Gaumnitz said.
“Moving to green lets us access that point with higher peak intensity, which directly translates to more photons per pulse.”
The work was funded by the European Research Council and the German Research Foundation. The group is now investigating whether the same guiding mechanism can support kilohertz repetition rates with average powers approaching the milliwatt level needed for metrology and resist testing.